Required Tools; How To Assemble The Pole Mount Kit - Furuno SATELLITE COMPASS SCX20 Operator's Manual

Hide thumbs Also See for SATELLITE COMPASS SCX20:
Table of Contents

Advertisement

• DO NOT apply the supplied adhesive to the four vent holes near the name plate.
1.3.2

Required tools

The following tools should be prepared in advance for this installation.
Phillips-head Screwdriver
Slotted Head Screwdriver
Wrench
Cable tie
Putty
1.3.3

How to assemble the pole mount kit

1. Thread the supplied lock nut onto the supplied pipe then tighten to the end of
thread as shown in the figure below.
2. Apply the adhesive around the threads of the pipe then attach the pole mount tex-
ture to the pipe.
3. Turn the assembly upside down, hold the pipe steady and tighten the lock nut
again with a wrench. The torque must be 15 N•m.
4. Wipe off the excess adhesive.
Note: Do not cover the five drain holes (shown in the figure below) with the adhe-
sive.
Name plate
Name plate
Bottom view of the antenna unit
Name
#2
For clamp bolts.
• For fixing the lock nut (opposite side dist. 32 mm)
• For fixing pole mount texture (opposite side dis. 8 mm))
Two pieces (at least), for fixing the antenna cable.
For securing the cable entrance of the pipe.
Lock Nut
Apply adhesive to threads.
Apply adhesive to threads.
Pipe
Vent hole (four places)
Vent hole (four places)
Note: Do not apply the
Note: Do not apply the
adhesive here.
adhesive here.
Remarks
Hold the pipe in place
Hold the pipe in place
Pole Mount
Pole Mount
and re-tighten the nut
and re-tighten the nut
Texture
Texture
with a wrench.
with a wrench.
1. INSTALLATION
1-5

Advertisement

Table of Contents
loading

Table of Contents