Interfaces; Alarm Input; Name; Alarm Output - Bosch TINYON IP 2000 WI Software Manual

Camera Browser
Interface
12

Interfaces

12.1

Alarm input

Configure the alarm triggers for the unit.
Select N.C. (Normally Closed) if the alarm is to be triggered by
opening the contact.
Select N.O. (Normally Open) if the alarm is to be triggered by
closing the contact.
12.1.1

Name

Enter a name for the alarm input. This is then displayed below
the icon for the alarm input on the LIVE page (if configured).
12.2

Alarm output

Configure the switching behavior of the output.
Select different events that automatically activate an output. For
example, turn on a floodlight by triggering a motion alarm and
then turn the light off again when the alarm has stopped.
12.2.1

Idle state

Select Open for the output to operate as a normally open
contact, or select Closed if the output is to operate as a
normally closed contact.
12.2.2

Operating mode

Select the way the output works.
For example, if you want an activated alarm to stay on after the
alarm ends, select Bistable. If you wish an activated alarm to
stay on for ten seconds for example, select 10 s.
12.2.3

Output follows

Select the event that triggers the output.
Bosch Security Systems
Interfaces | en
2015.01 | v1.59x | AM18-Q0676
83