Factory Reset; Setup Menu - Philips TAB8947 User Manual

1
Press the (MENU) button on the
remote control to select UPMIX or
Standard mode.
•
UPMIX: Create a Dolby listening
experience.
•
Standard: Two-channel stereo
sound. Ideal for listening to
music.

Factory Reset

Reset device to default setting
Set is ON, press and hold the Vol+
and Vol- buttons on the soundbar for
8 seconds until the soundbar display
panel shows "
RESET
reboot, soundbar display panel shows
" ".
REBOOT

Setup Menu

The unit allows you to configure
advanced settings to provide you with
an even better experience.
1
Press the
remote control to open the menu.
2
Select the content with VOL+/
VOL- (Down / Up) on the remote
controller.
". While system
(MENU) button on the
Description
Display
Select Surround Effect
Adjust the Bass Level
B XX
T XX Adjust the Treble Level
Set the Audio Delay
CT XX
Adjust the Center Channel Gain
dim Set display brightness
Auto turn off display
Activate the pairing function in
Bluetooth mode
BT PAIR
This item will only be displayed in
Bluetooth mode
MANUAL
Activate firmware upgrade
UPGRADE
ACCEPT TERMS OF USE IN
AUTO
MANUAL - PRESS PLAY(if 1st time
UPGRADE
switch from OFF to ON)
3
Change the initial values for each of
the settings with the cursors
(Left / Right).
4
To return to the previous screen/ exit
the settings, press
button is pressed within 10 seconds,
the system will automatically exit the
menu
Surround
•
UPMIX : Dolby up-mixing
technology apply for audio
channels lesser than the 5.1.2 or 7.1.2
speaker configuration.
•
STANDARD : The speaker
output follow the native channel
configuration of the content.
Tips
•
UPMIX support content input only as
following: PCM 2.0/Dolby 5.1/Dolby 7.1
/
(Back). If no
EN 21