Philips TAB8947 User Manual page 23

If ToU has been accepted,
Soundbar will perform firmware
upgrade if a new firmware is
detected from the server.
If there is no new firmware
found, Soundbar will scroll
current firmware version
once and resume to normal
operation.
During manual firmware
upgrading process, there are
downloading and flashing
processes.
Downloading process :
• TAB8947 can operate
normally.
• POWER key to enter semi
standby, downloading will
continue. Display should
keep displaying "UPDATING-
KEEP POWER ON". During
this stage, all local and RC
keys will have no effect
until firmware is upgraded
successfully.
• During semi standby,
in case downloading
has failed due to
server or network
issues, TAB8947
should cancel the
downloading process
and stay in standby.
• POWER key to enter
ECO standby will interrupt
downloading progress
and user needs to trigger
firmware upgrading manually
again.
Flashing firmware process :
• All local and RC keys will
have no effect.
• All current sources such as
C4A/Aiplay streaming, BT
streaming, HDMI In, Optical,
etc will stop its current
operation. This is to ensure
upgrading process will not be
interrupted.
• Keep displaying
"UPDATING-KEEP POWER
ON".
» Store the file into "/update/
data/" folder of the USB flash
drive. The firmware filename
should be "update_TAB8947_
Vxxxxx.zip". <xxxxx> is the
downloaded firmware version.
» TAB8947 is turned on.
» Plug in USB drive with the
downloaded firmware.
» Press SETTINGS on RC, press
UP/DOWN to navigate till
"MANUAL UPGRADE" item.
» Press RIGHT key will trigger
upgrading. Display will
show "UPDATING – KEEP
POWER ON" till upgrading has
completed.
AUTO UPGRADE
» Before Auto upgrade is enabled,
end user needs to read and
accept the Terms of Use in
manual.
» To turn on the AUTO upgrade
function, Press SETTINGS on RC,
press UP/DOWN to navigate till
"AUTO UPGRADE" item.
» Press RIGHT and display will
show "ACCEPT TERMS OF USE
IN MANUAL – PRESS PLAY"
» If end user has agreed, press
PLAY to turn on the function.
EN 23