Table of Contents
Advertisement
◦ If the command fails because the partner is "not ready", wait 5 minutes for the NVMEMs to
synchronize.
◦ If the command fails because of an NDMP, SnapMirror, or SnapVault process, disable the
process. See the appropriate Documentation Center for more information.
5. Wait 3 minutes and check the failover status with the
6. At the clustershell prompt, enter the
interfaces that are not on their home controller and port.
If any interfaces are listed as false, revert those interfaces back to their home port using the
net int revert -vserver Cluster -lif nodename
7. Move the console cable to the target controller and run the
ONTAP versions.
8. Restore automatic giveback if you disabled it by using the
local -auto-giveback true
9. Use the
storage encryption disk show
10. Use the
security key-manager key query
keys that are stored on the key management servers.
◦ If the
Restored
replacement process.
◦ If the
Key Manager type
yes/true, use the
IDs of the authentication keys.
If the command fails, contact Customer Support.
◦ If the
Key Manager type
use the
security key-manager onboard sync
Use the security key-manager key query to verify that the
all authentication keys.
11. Connect the console cable to the partner controller.
12. Give back the controller using the
13. Restore automatic giveback if you disabled it by using the
local -auto-giveback true
14. Restore Autosupport if it was disabled by using the
-type all -message MAINT=END
5.1.7. Return the failed part to Lenovo - DM3010H
If you are instructed to return the component, follow all packaging instructions,
net int show -is-home false
command.
at the clustershell prompt, to review the output.
command to display the key IDs of the authentication
column = yes/true, you are done and can proceed to complete the
=
and the
external
security key-manager external restore
=
and the
onboard
storage failover giveback -fromnode local
command.
storage failover show
command to list the logical
command.
version -v
storage failover modify -node
column = anything other than
Restored
command to restore the key
column = anything other than yes/true,
Restored
command to re-sync the Key Manager type.
Restored
storage failover modify -node
system node autosupport invoke -node *
command.
command to check the
column =
for
yes/true
command.
43
Advertisement
Table of Contents
