Table of Contents
Advertisement
If the system-level
diagnostics tests...
Were completed without any
failures
Resulted in some test failures
Then...
There are no hardware problems and your storage system
returns to the prompt.
a. Clear the status logs by entering the following command:
sldiag device clearstatus
b. Verify that the log is cleared by entering the following
command:
sldiag device status
The following default response is displayed:
SLDIAG: No log messages are present.
c. Exit
Maintenance
command:
halt
d. Enter the following command at the Loader prompt to boot
the storage system:
system-level diagnostics.
Determine the cause of the problem.
a. Exit
Maintenance
command:
halt
b. Perform a clean shutdown and disconnect the power
supplies.
c. Verify that you observed all the requirements for running
system-level
diagnostics,
connected, and that hardware components are properly
installed in the storage system.
d. Reconnect the power supplies and power on the storage
system.
e. Repeat Steps 1 through 5 of Running slow system
response diagnostics.
mode
by
entering
You have completed
boot_ontap
mode
by
entering
that
cables
the
following
the
following
are
securely
113
Advertisement
Table of Contents
