Table of Contents
Advertisement
If network discovery is not enabled
If network discovery is not enabled on your laptop, manually complete the configuration and
setup.
Steps
1. Cable and configure your laptop or console:
a. Set the console port on the laptop or console to 115,200 baud with N-8-1.
See your laptop or console's online help for how to configure the
console port.
b. Connect the console cable to the laptop or console, and connect the console port on
the controller using the console cable that came with your system, and then cConnect
the laptop or console to the switch on the management subnet.
c. Assign a TCP/IP address to the laptop or console, using one that is on the
management subnet.
2. Plug the power cords into the controller power supplies, and then connect them to power
sources on different circuits.
3. If you need to change the shelf IDs, continue with substeps a through e; otherwise, skip to
the next step below.
27
Advertisement
Table of Contents
