Table of Contents
Advertisement
If your system has...
No network connection
4. Ensure that the environmental variables are set as expected:
a. Take the controller to the LOADER prompt.
b. Check the environment variable settings with the
c. If an environment variable is not set as expected, modify it with the
variable-name changed-value
d. Save your changes using the
5. The next depends on your system configuration:
◦ If your system has onboard keymanager, LSE or LVE configured, go to
and LVE as
needed.
◦ If your system does not have onboard keymanager, LSE or LVE configured, complete the
steps in this section.
6. From the LOADER prompt, enter the
If you see...
The login prompt
Waiting for giveback...
7. Connect the console cable to the partner controller.
8. Give back the controller using the
9. At the cluster prompt, check the logical interfaces with the
command.
If any interfaces are listed as "false", revert those interfaces back to their home port using the
net int revert -vserver vserver_name -lif lif_name
10. Move the console cable to the repaired controller and run the
Then...
a. Press
when
n
configuration.
b. Reboot the system when prompted by the system.
c. Select the Update flash from backup config (sync flash)
option from the displayed menu.
If you are prompted to continue with the update, press y.
printenv
command.
command.
savenv
command.
boot_ontap
Then...
Go to the next Step.
a. Log into the partner controller.
b. Confirm the target controller is ready for giveback with the
storage failover show
storage failover giveback -fromnode local
prompted
to
restore
command.
setenv environment-
Restore OKM, LSE,
command.
net int show -is-home false
command.
command to check
version -v
the
backup
command.
41
Advertisement
Table of Contents
