Dometic GP-ADV-LIFEPO4-100 Installation And Operating Manual
Hide thumbs
Also See for GP-ADV-LIFEPO4-100:
- Quick start manual (2 pages) ,
- Quick start manual (2 pages)
Related Manuals for Dometic GP-ADV-LIFEPO4-100
Summary of Contents for Dometic GP-ADV-LIFEPO4-100
- Page 1 POWER & CONTROL BATTERIES GP-ADV-LIFEPO4-100, GP-ADV-LIFEPO4-300 Battery Installation and Operating manual............ 3...
- Page 2 Copyright © 2023 Dometic Group. The visual appearance of the contents of this manual is protected by copyright and design law. The underlying technical design and the products con- tained herein may be protected by design, patent or be patent pending. The trademarks mentioned in this manual belong to Dometic Sweden AB. All rights are reserved.
-
Page 3: Table Of Contents
This product manual, including the instructions, guidelines, and warnings, and related documentation, may be subject to changes and updates. For up-to-date product information, please visit documents.dometic.com. -
Page 4: Scope Of Delivery
• Do not connect the battery to a faulty or incompatible inverter, • Only Dometic authorized technicians can open, attempt to repair or disassemble the battery. If the factory seal is removed or broken, the warranty for the battery is void. -
Page 5: Technical Description
7 Technical description The advanced LiFePO4 battery offers the desired features like charging below freezing, series connected batteries as well as BLE and RV-C connectivity. The batteries are equipped with a Battery Management System (BMS) which is built in the battery housing. The battery management system is a non-power consuming, passive electronic device, that protects the battery against deep discharging, overcharging, over-temperature and ensures cellbalancing of all serial switched blocks during charging. - Page 6 power button with status LED RV-C Ports integrated heater for low temperature charging slanted sides prevent batteries from being installed without an air gap between them for cooling integrated screw holes for easy mounting. This works well for width limited enclosures staggered terminals allow parallel/series connections without much wire interference The 300 Ah battery has the following components:...
-
Page 7: Configuration
power button with status LED RV-C ports removable top lid for serviceability optional brackets for easy mounting to a wall handle clips in to keep it from flopping around integrated screw holes for easy mounting Easy mounting works well for width limited enclosures. ... - Page 8 2. Inter-battery communication is handled using the three cable types. system harness b. inter-battery harness terminator 3. To connect and configure multiple batteries: • connect the RV-C wires between the batteries as shown in the below diagram • configure the batteries using the Go Power! Connect app...
- Page 9 • the master battery can now communicate with the secondary battery/batteries NOTICE! Damage Hazard Make sure that the batteries are in power OFF mode before connecting. Configure the battery pack as follows: Hold down the power button for 2 seconds or charge to wake up each battery pack, battery enters power ON mode and LED is solid light. b.
- Page 10 Using the Advanced Lithium app Download the Go Power Connect! app. Note Add device for the GP-ADV-Lithium battery. 3. Setup one master battery by pressing and then configure each individual battery. 4. Press Indicate to blink the power LED for physical reference of the current battery configured. 5.
- Page 11 Operation Various Power Modes: Press button for more than 3 seconds and release. The battery will enter sleep mode. The LED will blink. Power off mode should only be used for long term storage or to reset the BMS.
-
Page 12: Cleaning
10 Cleaning The lithium batteries are maintenance-free. Occasionally clean the product with a damp cloth. 11 Storage Battery is shipped in shutdown mode, and SOC is about 30 % by air shipment, about 50 % SOC by sea shipment. The storage environment requirement is as follows: -20 °C~25 °C ＜... -
Page 13: Warranty
14 Warranty Go Power! warrants the GP-ADV-LIFEPO4-100 for a a pro-rated period of ten (10) years from the date of shipment from its factory. Please visit our knowledge base online for the pro- rates. This warranty is valid against defects in materials and workmanship for the ten (10) year warranty period. It is not valid against defects resulting from, but not limited to: •... - Page 14 100 Ah 300 Ah Long term storage If the battery needs to be stored for > 3 months the voltage should be 13.2 V(50 %SOC), and stored at the storage specifications shown above. Additionally, the battery needs at least one charge & discharge cycle every six months. Balancing balance start voltage cell≥...
- Page 15 100 Ah 300 Ah charge mode: cell max temp>=57 °Cor MOSFET temp>=105 °C High temperature alarm clear cell max temp<=55 °Cor MOSFET temp<=90 °C Low temperature alarm min cell temp<3 °C Low temperature alarm clear min cell temp>=5 °C Discharge current alarm discharge current>130 A Discharge current alarm clear...