Tank Preparation - 3scort TD-150 User Manual

Tank preparation

To prepare the tank, you need to:
● Empty the tank and clean it from any dirt if necessary
● Remove any fuel vapors and fumes (especially if it is a gasoline/petrol tank);
to do so you can boil some water in a separate recipient and administer the
vapor from that recipient into the tank so it could "push" the fuel vapors and
fumes out; be sure to keep the fire used to boil the water far enough from the
fuel tank (Fig 1)
● Find the geometric center of the tank (Fig. 2) and drill a little hole in it using
a ø3mm bit then probe the space around for any reinforcement plates or
baffles inside the tank using a piece of wire (Fig. 3);
Fig. 1 Removing fuel vapors
7