Sensor Configuration And Fine-Tuning - 3scort TD-150 User Manual

Be sure to check out
assembled in real time.
Sensor configuration and fine-tuning
The sensor can be configured by means of a configuration tool for PC (hereinafter
– "configurator") or by means of a mobile application installed on an Android OS device.
This instruction will be focused on the PC configurator.
Connect the sensor to a USB-RS485 converter via the 6 pin MOLEX connector
or via the clamps and wires (if the extension cable is already connected to the sensor).
The orange wire is the line A of the RS485 output of the sensor, the white wire is the
line B of the RS485 output, the black wire is the GND and the red wire is the PWR.
We recommend using the USB-RS485 converter C200M manufactured by our
company since we cannot ensure 100% compatibility of our devices with the converters
of other brands.
Connect USB TYPE A end of the wire to the usb port of the computer or laptop and the
micro USB to the USB connector of the C200M.
If using a PC or laptop, connect the converter to its USB port via a USB cable.
Fig. 11 Connecting the C200M to the laptop. Sensor disconnected
If using a laptop, better plug it in into a local electricity socket and/or connect an
extra USB cable to the ADD PWR port of the C200M. Otherwise, there could be not
enough power for the sensor to work.
this video on our YouTube channel to see the coupling
13