Sensor Calibration - 3scort TD-150 User Manual

When the sensor is connected, you should be able to see the following data:
1) Sensor's serial number
2) FW version
3) Network address of the sensor (its ID used for the RS485 connection)
4) Status message with the sensor's current status
5) Current readings of the sensor
6) Current mode of the sensor, range of the output data (1-1023 or 1-4095) and
filtration type and level

Sensor calibration

After you cut or extended the length of the sensor's tubes, you need to
recalibrate it.
You can do the calibration without fuel to do so you need to enter the sub
menu "Sensor calibration" (Fig. 23).
Fig. 22 Main menu of sensor configurator
19