3scort TD-150 User Manual page 45

the empty calibration value. Try and recalibrate the sensor. If it doesn't help,
take a screenshot of the configurator and send it to us. Current and Full and
Empty calibration values must be clearly visible!!!
7000 is a code for short circuit. It means that there's some dirt, water or
admixtures between the tubes of the sensor that affect its readings. The current
level in such case will be higher than the full calibration value. If this
happens, blow the sensor through its drainage holes with compressed air and
flush it with pure fuel. Also, consider cleaning the tank to prevent the short
circuit from happening again.
If your sensor doesn't connect to the configurator, be sure to do the
following:
- check if the right COM port is selected in the configurator and if you have
the right drivers for your converter (in case of the C200M it should be
Fig. 53 6500 and 700 check
45