Sensor Preparation - 3scort TD-150 User Manual

Sensor preparation

Before calibrating the sensor, you need to adjust the length of its measuring
tubes according to the height of the tank by either cutting or extending them. The
length of the tubes should be calculated based on the following formula:
where L is the length of the tubes after they were cut or extended and H is the
height of the tank at the installation spot.
ATTENTION!!!
(150 mm). Otherwise the sensor will not work properly.
The maximum length
The minimum length
of the tubes can reach
Fig. 6 Measuring the height of the tank
L = H - 15 mm,
of the tubes must not be less than
6 m.
15 cm
10