Xinje DS2 Series Manual page 55

E-008
Over speed
E-009
Analog input
error
E-010
Position offset
too large
E-011
Motor UVW is
short circuit
E-012
Motor UVW
current error
E-013
Encoder UVW
wire break
E-014
Encoder ABZ
wire break
E-015 Speed changes
too fast
(encoder
feedback error)
Motor speed is too fast,
motor UVW connection is
error
Input voltage error when
2-channe analog zero
calibrating
The difference between set
position and actual position
exceeds the limit value
External is short circuit
when fist self-test
Current collection circuit
error
Encoder wiring error,
encoder broken, encoder is
not connected
Encoder wiring error,
encoder broken, encoder is
not connected
The encoder wiring is error,
or the encoder has
interference
Check if there is other device
that make motor revolve too
fast; check the UVW wiring.
Input correct voltage when zero
calibration for analog
Check if the motor stalled,
decrease the set position speed,
increase offset pulse limit value
P5-05
Check the UVW wiring of
motor, or replace the damaged
motor
Check the UVW wiring of
motor, or replace the damaged
drive
Check the wiring of encoder,
and re-connect the encoder after
power-off, or replace the
damaged encoder
Check the wiring of encoder,
and re-connect the encoder after
power-off, or replace the
damaged encoder
Check the wiring of encoder, or
add shield layer for the encoder
wire
55