Sony CDP-XE530 Service Manual page 9

4-3. AGING MODE
This unit is equipped with an aging mode to check operations of the
mechanism deck.
• When faults occur:
Aging stops, and the state when aging stopped is displayed on the
fluorescent display tube.
• When no fault has occurred:
Aging is continued repeatedly.
Aging method 1
(When using the aging mode remote controller (J-2501-123-A)):
Press the U button and turn ON the power.
1.
2. Set the disc on the tray.
3. Press the AGING START button of the aging remote controller.
4. Aging starts and the message shown in Fig. 1 is displayed on
the fluorescent display tube.
To end, press the U button.
5.
Aging method 2 (When no aging mode remote controller):
Press the U button and turn ON the power.
1.
2. Set the disc on the tray.
Press the § OPEN/CLOSE button, p button, and MUSIC
3.
SCAN button at the same time. (If these buttons are not pressed
at the same time, nothing performs.)
4. Aging starts and the message shown in Fig. 1 is displayed on
the fluorescent display tube.
To end, press the U button.
5.
Fig. 1 Message in Aging Mode
Code
State
No.
0 Load in
1 Access to TOC
2
Access to last track
3 Playback of last track
(3 seconds)
4
Access to first track
5 Playback of first track
(3 seconds)
6
Load out
Display when Display when
normal abnormal
AGING-0
ERROR-0
AGING-1
ERROR-1
AGING-2
ERROR-2
Counter display
ERROR-3
AGING-4
ERROR-4
Counter display
ERROR-5
AGING-6
ERROR-6
[ MAIN BOARD ] – Component Side –
JW613 (ADJ)
JW617 (AFADJ)
— 9 —
CN621