THIS NOTE IS COMMON FOR PRINTED WIRING
BOARDS AND SCHEMATIC DIAGRAMS.
(In addition to this, the necessary note is printed
in each block.)
For schematic diagrams.
Note:
• All capacitors are in µF unless otherwise noted. pF: µµF
50 WV or less are not indicated except for electrolytics
and tantalums.
• All resistors are in Ω and
1
/
W or less unless otherwise
4
specified.
•
¢
: internal component.
• C : panel designation.
Note: The components identified by mark ! or dotted line
with mark ! are critical for safety.
Replace only with part number specified.
• U : B+ Line.
• V : B– Line.
• Voltages and waveforms are dc with respect to ground
under no-signal (detuned) conditions.
no mark : STOP
(
) : PLAY
• Voltages are taken with a VOM (Input impedance 10 MΩ).
Voltage variations may be noted due to normal produc-
tion tolerances.
• Waveforms are taken with a oscilloscope.
Voltage variations may be noted due to normal produc-
tion tolerances.
• Circled numbers refer to waveforms.
• Signal path.
J
: CD
c : digital out
For printed wiring boards.
Note:
• X : parts extracted from the component side.
• Y : parts extracted from the conductor side.
•
: parts mounted on the conductor side.
p
•
: Through hole.
®
• b : Pattern from the side which enables seeing.
(The other layers' patterns are not indicated.)
Caution:
Pattern face side: Parts on the pattern face side seen from the
(Side B)
pattern face are indicated.
Parts face side: Parts on the parts face side seen from the
(Side A)
parts face are indicated.
• Indication of transistor
C
Q
These are omitted
B
E
B
C
E
These are omitted
• Waveforms
1
IC101 &¡ XTAI
3.9Vp-p
33.8MHz
2
IC101 %º RF AC
1.2Vp-p
(PLAY)
3
IC101 $¡ TE
2.5V
APPROX 500mVp-p (PLAY)
4
IC101 #ª FE
2.5V
APPROX 200m Vp-p (PLAY)
5
IC101 @∞ MDP
2.4Vp-p
7.5µsec
6
IC661 6 384FS
4.5Vp-p
33.87MHz
7
IC661 0 BCK
5Vp-p
2.1MHz
8
IC661 @¡ XOUT
3.3Vp-p
33MHz
9
IC501 #ª EXTAL
3.9Vp-p
8MHz
— 13 —
6-2. SCHEMATIC DIAGRAM – LOADING MOTOR SECTION –
6-3. PRINTED WIRING BOARD – LOADING MOTOR SECTION –
LOADING BOARD
CN151
S151
5
LOAD
OUT
1
(Page 19)
CDP-XE530
(Page 21)
• See page 12 for Circuit Board Location.
S152
LOAD
IN
M
M151
LOADING
MOTOR
11
(21)
1 - 6 4 5 - 7 2 1 -
— 14 —