Table of Contents
Advertisement
05
Lightly grease the bore and collet nut interface
on the Front Triangle main pivot interface Install
Lower Switch Link Assembly (4.1) with two Race
Extenders (4.15) into the Front Triangle and secure
with 15mm Collet Axle (4.8) and Chain guide
Mount Collet Nut (4.47).
Torque to 20-25 Nm
09
Install Cable Port Cover, Single (4.27) to the inside of the chainstay non-drive side surface and secure
lightly with M4 FHCS (4.20).
Repeat installation of port cover on Front Triangle non-drive side.
YETI 160E | OWNER'S MANUAL
06
Lightly grease bore and collet nut interface of
chainstay main pivot interface. Install remaining
15mm Race Extenders (4.15) onto Lower Link (4.1)
and place chainstay onto Link. Secure with 15mm
Collet Axle (4.8) and Cable Clamp Collet Nut (4.58).
Torque to 20-25 Nm
07
Install 2x Bearing Reducer, Large Flange (4.17)
and 2x Bearing Reducer, Small Flange (4.16) to the
outides and insides of the Rocker Link Assembly
rear bearings.
Repeat for seatstay Clevis interface.
10
Install Switch Link Fender (4.38) to the Front
Triangle using 2X FHCS (4.20) Torque to 2.5 Nm or
until snug.
FRAME ASSEMBLY
08
Install seatstay onto frame, aligning first at the
Rocker Link Assembly. Use 12mm guide pin to
align and secure with 2X Clevis Bolt (4.14). Align
the chainstay and seatstay clevis interface using
12mm Guide Pin and secure with 2X Clevis Bolt
(4.14).
Torque all clevis bolts to 12 Nm
11
Tighten non-drive side Rocker Link pinch bolt
and torque to 5-6 Nm Torque the 2X M4 FHCS
securing the Rocker Links and Bridge to 5 Nm.
Note: This bolt must be loosened prior to link
removal.
TABLE OF CONTENTS |
11
Advertisement
Table of Contents
