Table of Contents
Advertisement
25
Install Battery (4.6.2) into the downtube. Battery
should clip in firmly and latch without pinching any
wires or housing. Install Battery Guard (4.7) onto
the Battery using 4x M4 BHCS (4.63). Snug the 4x
BHCS until hand-tight.
29
Install Cable Clamp, chainstay Collet Nut (4.57)
onto the Collet Nut, Housing Clamp (4.58) by
inserting the small tab under the collet nut
overhang. Secure with M3 x 10L Cap Screw
(4.56). Tighten screw until snug around housing,
or hand-tight if assembling a wireless drivetrain kit.
If overtightened, shifting performance can
be effected.
YETI 160E | OWNER'S MANUAL
26
Install Battery Guard (4.7) onto the Battery using 4x
M4 BHCS (4.63). Snug the 4x BHCS until hand-tight.
30
Install Base, Housing Clamp, chainstay Collet
Head (4.54) and Clamp, Housing Clamp, chainstay
Collet Head (4.55) into the non-drive side collet
head in the chainstay with a M3 x 25L FHCS (4.33).
Ensure that brake line and speed sensor wire have
adequate strain relief to the front triangle and not
being pulled, tugged, or bent throughout travel.
Tighten clamp around Speed Sensor wire and
brake housing until snug (hand-tight).
27
Install OnesUp O-Ring onto the Chainguide Mount
Shoulder Bolt (4.50). Secure OneUp Components
Chainguide (outer and inner, 4.51 and 4.52) with
Shoulder Bolt (4.50) onto the Chainguide Mount
Collet Nut (4.47).
Add enough spacers behind top guide to ensure
chainring is centered in the guide.
31
Install a Shift + E Cable Port Cover (4.24) or E-Only
Cable Port Cover (4.25) (kit-dependent) with a Cable
Port Cove Base (4.22) onto the drive-side headtube
and secure with M4 FHCS (4.19). Tighten until snug.
Install a Shift + Brake Cable Port Cover (4.23) or
Brake-Only Cable Port Cover (4.26) (kit-dependent)
with a Cable Port Cover Base (4.22) onto the non-
drive side headtube and secure with M4 FHCS
(4.19). Tighten until snug.
E-COMPONENT ASSEMBLY
28
Install Housing Clamp, Chainguide Mount (4.48)
around shifter housing (if applicable) and onto the
Chainguide Mount Collet Nut (4.47) using 1x M3
FHCS (4.49). Tighten until snug. If overtightened,
shifting performance can be effected.
32
Install Shimano Chainring onto Motor and secure
with chainring Lockring. Note that Lockring is
LEFT HAND thread. Torque to 35-45 Nm using
crow's foot attachment. Ensure chainring sits in
between chainguide halves.
33
Install Shimano cranks per manufacturer
instructions. Install crankarm cap and tighten to
0.7 - 1.5 Nm. Torque 2X Crank Arm pinch bolts to
12-14 Nm
TABLE OF CONTENTS |
16
Advertisement
Table of Contents
