Handlebar Wiring - Yeti EP801 Owner's Manual

HANDLEBAR WIRING

01
- Insert the mode switch wire (Orange) in the hole in the left side of the handlebar and push until it exits the
left side of the bar end.
- Using an internal cable routing tool (Yellow), insert the tool into the hole near the center of the handlebar
and push through until it exits the left side bar end.
- Connect the mode switch wire (Orange) to the internal cable routing tool (Yellow) and pull the internal
cable routing tool back through the hole at the center of the handlebar.
03
- Install the Shimano cycle computer onto the handlebar, directly to the right of the stem. Use a 3mm hex
wrench to tighten the clamp bolt to 0.8Nm (7.1 in-lb).
- The wire from the mode switch routes through the handlebar and connects into the left port of the cycle
computer. After connecting the mode switch wire, tuck the excess wire back into the handlebar.
YETI 160E | OWNER'S MANUAL
02
- Install the mode switch in the correct location next to the grip on the rider's left side of the handlebar.
Take care to ensure the mode switch wire is aligned in the groove under the bar and passes under the
clamp before connecting to the mode switch. Use a 3mm hex wrench to tighten the mode switch clamp
bolt to 1.5Nm (13.8 in-lb). Ensure that the mode switch wire is seated in the groove when installing the
grip to avoid damaging the wire.
E-COMPONENT ASSEMBLY
TABLE OF CONTENTS | 18