Product Operation & Specifications - Ispring WHOLE HOUSE WCS45KG Installation Instructions & User Manual

Though testing was performed under standard laboratory conditions, the system's performance may
vary based on local water conditions and quality.
Working Pressure Limits (min./max.)
Water Temperature Limits (min./max.)
Required Riser Pipe Diameter
Electrical Adapter
Pressure Tank Thread
Inlet/Outlet Connector
Rated Service Flow Rate
Peak Flow Rate
Capacity
● This system is designed to be used on a cold supply ONLY and kept away from freezing
environments.
● All inlet and outlet pipes are recommended to use water pipes and fittings that meet the
appropriate standards of domestic drinking water. The connection of water pipes and circuits
should comply with national or industry standards, and the pipe connections should comply
with relevant federal installation regulations.
● If the water inlet pressure is higher than 64 psi, a pressure-reducing valve must be installed at
the water inlet pipe of the water purifier. If the water inlet pressure is lower than 21 psi, a
booster pump must be installed at the water inlet pipe of the water purifier to ensure the
working pressure meets technical requirements.
● Heat preservation measures should be executed if the inlet water temperature is higher or lower
than the requirement.
Note
◼
Failure to operate the product per this manual may result in product damage, water leakage,
seepage, injury, or other losses.
For questions or concerns, call 1-678-261-7611, email Support@123filter.com, or visit
www.123filter.com
Product Operation & Specifications
SPECIFICATIONS
www.ispringfilter.com/support.
| +1 (678) 261 - 7611 |
21~64 psi
40~100 ° F
(4~39 ° C)
1.050 inch (26.7 mm)
Input: AC 120 V, 60 Hz
Output: AC 12 V, 650 mA
2.5" NPSM
1" NPT
8 GPM (30 L/min.)
26 GPM
45000 grain
support@123filter.com Page 5