VTech SIP Contemporary Series User Manual page 3

• If the product does not operate normally
by following the operating instructions.
Adjust only those controls that are covered
by the operation instructions. Improper
adjustment of other controls may result
in damage and often requires extensive
work by an authorised technician to
restore the product to normal operation.
• If the product has been dropped and
the telephone base and/or handset has
been damaged.
• If the product exhibits a distinct change
in performance.
15. Avoid using a telephone (other than
cordless) during an electrical storm.
There is a remote risk of electric shock
from lightning.
16. Do not use the telephone to report a
gas leak in the vicinity of the leak. Under
certain circumstances, a spark may be
created when the adapter is plugged into
the power outlet, or when the handset is
replaced in its cradle. This is a common
event associated with the closing of any
electrical circuit. The user should not
plug the phone into a power outlet, and
should not put a charged handset into
the cradle, if the phone is located in an
environment containing concentrations
of flammable or flame-supporting gases,
unless there is adequate ventilation. A
spark in such an environment could create
a fire or explosion. Such environments
might include: medical use of oxygen
without adequate ventilation; industrial
gases (cleaning solvents; petrol vapours;
etc.); a leak of natural gas; etc.
17. Only put the handset of your telephone
next to your ear when it is in normal talk
mode.
18. The power adapters are intended to be
correctly oriented in a vertical or floor
mount position. The prongs are not
designed to hold the plug in place if it is
plugged into a ceiling, under-the-table
or cabinet outlet.
19. Use only the power cord and batteries
indicated in this manual. Do not dispose
of batteries in a fire. They may explode.
Check with local codes for possible
special disposal instructions.
20. In wall mounting position, make sure to
mount the telephone base on the wall by
aligning the eyelets with the mounting
studs of the wall plate. Then slide the
telephone base down on both mounting
studs until it locks into place. Refer to the
full instructions in Installation in the user's
manual.
21. This product should be mounted at a
height of less than 2 meters.
22. Listed PoE (The product is considered not
likely to require connection to an Ethernet
network with outside plant routing)
CAUTIONS
• Keep small metallic objects such as pins
and staples away from the handset
receiver;
• For pluggable equipment, the socket-
outlet (power adapter) shall be installed
near the equipment and shall be easily
accessible;
• The applied nameplate is located at the
bottom of the product;
• The equipment is only used for mounting
at heights < 2m.
SAVE THESE INSTRUCTIONS
EN - 3
.