Pioneer QUANTUM INVERTER Series Owners And Installation Manual page 24

Connect the wire to the terminal according to
●
the wire connecting diagram.
Fix the wire with the clip by using the two screws.
●
Page 24
 
Select one to
connect ground
wire
TO INDOOR UNIT MAIN BOARD
1 2 3
TO OUTDOOR UNIT
Install the terminal cover by xing the two screws.
●
2. Install the indoor air handler
NOTICE NOTICE
After you have nished installing the main body,
when choosing where to start, determine the
direction of the pipes to be drawn out.
Especially in cases where there is a ceiling involved,
align the refrigerant pipes, drain pipes, and indoor
and outdoor lines with their connection points
before mounting the unit.
After you selecting an installation location, drill
●
a hole with the diameter of 6mm or less into
the roof beam based on the layout of the
installation board (accessory
cardboard template
remove the installation board.
430mm
(16.93'')
Installation cardboard template
Two screws
Installation
). After drilling the hole,
1300mm(51.18'')
CUTTING LINE