Waldorf RNL8200G Installation And Operation Manual page 26

1. Carry out the following:-
 Remove griddle plate section and heat
shield.
 Remove main burner.
 Disconnect piezo igniter from mounting
bracket. (For access purposes).
 Disconnect pilot supply tube from pilot
burner to access pilot injector.
2. With Main Burner removed, ensure aeration gap is adjusted for
type of gas being used as shown in 'Gas Specifications Tables'
at rear of this section.
3. Remove pilot and main injectors and replace with correct size
injectors as shown in 'Gas Specifications Tables' at rear of this
section.
4. Refit the following:-
 Re-connect pilot supply tube to pilot burner.
 Re-connect piezo igniter to mounting bracket.
 Refit main burner, gas control heat shield and griddle plate to cooktop.
5. Re-light main burners and check flame size on 'Low' flame position.

Adjust low fire adjustment screw on open burner gas control valves to
obtain desired flame size.
NOTE: The 'Low Fire Screw' should be sealed with coloured paint on
completion of low fire adjustment.
Piezo Igniter
Pilot Burner
24
Pilot Supply
Tube
Main Burner Injector
Burner Adjustment Screw
Aeration Slide
Low Fire Screw