LG STB-3500 Setup Manual page 48

Cloning Procedures (Cont.)
(Continued from previous page)
• If the TLX file contains an FTG Channel Map that was Learned from a Master STB, the physical
RF channels in the FTG Channel Map have been assigned logical channel numbers (see
"Learning Configuration from a Master STB" above). When you Teach the FTG Channel Map
to the Target STB(s), you will have the option to select either logical or physical channel tuning.
Even if you select physical channel tuning, the (list of) physical RF channels in the FTG Channel
Map will remain in logical order.
• If the TLX file contains an FTG Channel Map that was created in the FTG File Manager, each
logical channel number in the FTG Channel Map has been assigned a physical RF channel, an
IP channel, or an Aux input (the latter designated by 130-0 through 137-0—see also Reference
section, "STB Aux Input Configuration").
Note: If the FTG Channel Map includes RF channels and Aux inputs only, you will have the option,
during Teaching, to select either logical or physical channel tuning. If you select physical channel
tuning, the physical RF channels and Aux inputs in the FTG Channel Map will remain in logical
order. Physical channel tuning is not available when the FTG Channel Map includes IP channels.
• If the Target STB EBL is already in FTG Mode, you cannot use this procedure to make changes
to the FTG Channel Map and FTG Installer Menu settings. You must use a direct PC-to-STB
connection as described in Reference section, "FTG Mode via EBL (Local Configuration)," or an
FMA head end device to reconfigure the EBL.
• If the preceding condition applies, but you wish to switch the STB to FTG Mode via CPU, see
Reference section, "Restoring Factory Defaults on the STB(s)," for further information before
proceeding.
• If the TLX file was edited/created in the FTG File Manager, it may contain multiple zoned FTG
Installer Menu profiles for different STB/TV models. Make sure it includes the appropriate Installer
Menu profile(s) for the Target STB(s) before Teaching.
Caution: Do not unplug the STB power cord or remove the USB memory device
while Teaching is in progress, as doing so may cause the STB to malfunction or harm
the USB device, respectively.
Teach Configuration to Target STB
1. Turn ON the Target STB/display panel.
2. The next step depends on whether the EZ-Manager Wizard appears on the screen when you
turn ON the STB/display:
• If the wizard is displayed, you can complete the Teaching process via the wizard, as indicated
above (see "Before You Begin"). However, to continue with this procedure and access the
"Teach To STB (TLX)" option from the STB menus, exit the EZ-Manager Wizard. Then,
continue with step 3.
• If the wizard is not displayed, go directly to step 3.
3. If applicable (see also "Before You Begin" above), make sure to assign the appropriate Zone
designation(s) in the Target STB at this time.
Note: In order for the proper location-specific TV Zone and/or Wi-Fi Zone profile
data to be applied, the Zone designation(s) must be assigned in the Target STB(s)
BEFORE Teaching is initiated.
48
(Continued on next page)
206-4276