Using The Installer Menu; Exiting The Installer Menu And Activating Settings - LG STB-3500 Setup Manual

Installer Menu (Cont.)
As part of the Installer Menu header (in all modes), two 3-character acronyms are displayed to
indicate the STB's current configuration mode. The table below lists all possible mode identifiers
for the STB-3500.
Acronym Description
CPU-CTV Pass-through Mode with Channel Map in CPU
CPU-FTG FTG Mode via CPU
CPU-P:C Application Tuning Mode via CPU
EBL-FTG FTG Mode via EBL
EBL-LNT SONIFI PPV Mode
MPI-EXT External MPI Control
PTC-CTV Pass-through Mode with Channel Map in PTC

Using the Installer Menu

Refer to the table starting on the next page for an overview of the available Installer Menu items,
including their item numbers, functions, value ranges, and default values.
Installer Menu items not relevant to the STB are not present in the Installer Menu; therefore, some
numbers are missing. For example, item 006 will not appear. In addition, items that are dependent
on other Installer Menu item settings will not be initially accessible. For example, item 046 STRT
AUX SRCE will not display in the Installer Menu unless item 004 STRT CHANNEL is set to 0. See
Installer Menu detailed descriptions for further information.
Navigation within the Installer Menu
Use the Up/Down arrow keys on the Installer Remote to sequence through the available menu items,
or access an item directly by keying in the item number and then pressing MENU. For example, to
access the SLEEP TIMER option, which is item 015, press 0-1-5 + MENU.
Changing Installer Menu Settings
To change an Installer Menu item value, use the Left/Right arrow keys on the Installer Remote, or
enter a valid value directly. To save the new setting, press OK, or use the Up/Down arrow keys to
navigate to a new Installer Menu item if you have additional items to edit. Note that invalid values
will not be saved.

Exiting the Installer Menu and Activating Settings

After you have adjusted all required Installer Menu item settings, press OK once on the Installer
Remote to save your changes; then, press OK again to exit the Installer Menu. Any changes you
make will be stored in non-volatile memory.
Note: Each time you exit the Installer Menu in Pass-through Mode, all V-Chip (Parental Control)
settings in the STB are reset to their default values; that is, the Lock System, if previously enabled
from the Lock setup menu, will now be disabled, and the individual Parental Control settings will be
restored to default values.
Caution: Installer Menu settings may affect options available
from the STB setup menus or the Function Menu.
32
206-4276