Sonar Functions
Voice Command
Show Traditional Sonar
Show Clear View
Show Side View
Show Live Scope
Increase Sonar Gain
Decrease Sonar Gain
Sonar Gain Automatic
Increase Sonar Range
Decrease Sonar Range
Sonar Range Automatic
GRID Remote Control
Pairing the GRID Device with the Chartplotter from the Chartplotter
NOTE: These steps are applicable to both the GRID device and the GRID 20 device.
Before you can pair the GRID 20 device with the chartplotter to make the data connection, you must supply
power using batteries, the included power cable, or a NMEA 2000 network connection.
Before you can pair the GRID device with the chartplotter, you must connect it to the Garmin Marine Network.
1 Select Settings > System > Station Information > GRID™ Pairing > Add.
2 Select an action:
• On the GRID remote input device, press SELECT.
• On the GRID 20 remote input device, press
Pairing the GRID Device with the Chartplotter from the GRID Device
NOTE: This is not applicable to the GRID 20 device.
1 On the GRID remote input device, press + and HOME at the same time.
A selection page opens on all of the chartplotters on the Garmin Marine Network.
2 Rotate the wheel on the GRID remote input device to highlight Select on the chartplotter you want to control
with the GRID remote input device.
3 Press SELECT.
Rotating the GRID Remote Input Device
For certain installation situations, you can rotate the orientation of the GRID device.
NOTE: This is not applicable to the GRID 20 device.
1 Select Settings > Communications > Marine Network.
2 Select the GRID device.
24
Function
Opens the traditional sonar screen
Opens the Garmin ClearVü
Opens the Garmin SideVü
Opens the LiveScope screen
Increases the sonar gain level
Decreases the sonar gain level
Sets the sonar gain level to adjust automatically
Increases the sonar range
Decreases the sonar range
Sets the sonar range to adjust automatically
and
until the remote control beeps three times.
sonar screen
™
sonar screen
™
Controlling the Chartplotter