Customizing The Autopilot Button Actions; Controlling The Autopilot With A Grid 20 Remote Control; Reactor™ Autopilot Remote Control; Pairing A Reactor Autopilot Remote Control With A Chartplotter - Garmin GPSMAP 84 Series Owner's Manual

Customizing the Autopilot Button Actions

Before you can set the autopilot button actions, you must install and configure a compatible Garmin autopilot.
You can select up to three autopilot actions for your Garmin watch to perform.
NOTE: Available autopilot actions depend on the autopilot installed.
1 On the chartplotter, select Communications > Wireless Devices > Connect IQ™ Apps > Autopilot Control >
Button Actions.
2 Select a button.
3 Select an action.

Controlling the Autopilot with a GRID 20 Remote Control

• Press the knob to change the mode.
• While in step steering mode, turn the knob to steer.
Each turn of the knob produces a 1-degree step turn.
• While in autopilot response mode, turn the knob to adjust the Response setting.
• While in rudder steering mode, hold the joystick to the right or left to steer.
Reactor Autopilot Remote Control
™
You are responsible for the safe and prudent operation of your vessel. The autopilot is a tool that enhances
your capability to operate your boat. It does not relieve you of the responsibility of safely operating your boat.
Avoid navigational hazards and never leave the helm unattended.
You can wirelessly connect a Reactor autopilot remote control to the chartplotter to control the compatible
Reactor autopilot system.
For more information about using the remote, see the Reactor autopilot remote control instructions at
garmin.com

Pairing a Reactor Autopilot Remote Control With a Chartplotter

1 Select Settings > Communications > Wireless Devices > Wireless Remotes > Autopilot Remote.
2 If necessary, select Enable.
3 Select New Connection.
4 On the remote control, select
The chartplotter beeps and shows a confirmation message.
5 On the chartplotter, select Yes to complete the pairing process.

Changing the Functions of the Reactor Autopilot Remote Control Action Keys

You can change the patterns or actions assigned to the Reactor autopilot remote control action keys.
1 Select Settings > Communications > Wireless Devices > Wireless Remotes > Autopilot Remote > Button
Actions.
2 Select an action key to change.
3 Select a pattern or action to assign to the action key.
106
WARNING
> Pair with MFD.
Autopilot