Enabling Screen Lock; Turning On The Chartplotter Automatically; Automatically Turning Off The System; Customizing Pages - Garmin GPSMAP 9000 Series Owner's Manual

Enabling Screen Lock

For anti-theft protection and to prevent unauthorized use of your device, you can enable the Screen Lock feature
which requires a PIN (Personal Identification Number). When enabled, you must enter the PIN to unlock the
screen each time you turn on the device. You can set up recovery questions and answers as prompts in case
you forget the PIN.
If you enable the Screen Lock feature, Garmin Support cannot retrieve the PIN or access your device. It is your
responsibility to provide the PIN to anyone authorized to use the vessel.
1 Select Settings > System > Sounds and Display > Screen Lock > Setup.
2 Enter a memorable numeric PIN of 6 digits.
3 Reenter the PIN to verify.
4 When prompted, choose and answer three PIN recovery questions.
You can Disable or Reset the PIN and recovery questions as needed.

Turning On the Chartplotter Automatically

You can set the chartplotter to turn on automatically when the power is applied. Otherwise, you must turn on the
chartplotter by pressing
Select Settings > System > Auto Power Up.
NOTE: When Auto Power Up is On, and the chartplotter is turned off using
reapplied within less than two minutes, you may need to press

Automatically Turning Off the System

You can set the chartplotter and the whole system to turn off automatically after it has been asleep for the
selected length of time. Otherwise, you must press and hold
1 Select Settings > System > Auto Power Off.
2 Select an option.

Customizing Pages

Customizing the Startup Screen

You can personalize the image that is displayed when the chartplotter is turning on. For the best fit, the
image should be 50 MB or less and conform to the recommended dimensions
Dimensions, page 17).
1 Insert a memory card that contains the image you want to use.
2 Select Settings > System > Sounds and Display > Startup Image > Select Image.
3 Select the memory card slot.
4 Select the image.
5 Select Set as Startup Image.
The new image is shown when turning on the chartplotter.
16
.
NOTICE
to restart the chartplotter.
to turn off the system manually.
, and power is removed and
(Recommended Startup Image
Customizing the Chartplotter