Detaching And Refitting The Rails; Detaching And Attaching The Oven Door - Bosch HCE743222M Instruction Manual

Cleaning the self-cleaning surfaces in the oven
The back wall, roof and side walls of the oven are coated with
self-cleaning enamel. This coating absorbs and dispels
splashes from baking and roasting while the oven is in
operation. You will obtain a better result, the higher the
temperature and the longer the oven is in operation.
If soiling is still visible after several uses, proceed as follows:
First clean the oven floor.
1.
Set the oven to top and bottom heating.
%
2.
Heat the empty oven for approx. 2 hours at maximum
3.
temperature.
The ceramic coating is regenerated. Brownish and black
residues can then be removed with water and a soft sponge.
Slight colour variations of the coating have no effect on the self-
cleaning function.
Caution!
Never use abrasive cleaners. This could scratch or damage
■
the highly porous surface coating.
Do not use oven cleaner on self-cleaning surfaces. If oven
■
cleaner is accidentally applied to these surfaces, wipe it away
immediately with a sponge and plenty of water.
Cleaning the cooking compartment floor
Use a dish cloth and hot soapy water or a vinegar solution.
If there are heavy deposits of dirt, use a stainless steel scouring
pad or oven cleaner. Only use when the cooking compartment
is cold. Never treat the self-cleaning surfaces with a scouring
pad or oven cleaner.

Detaching and refitting the rails

The rails can be removed for cleaning. The oven must have
cooled down.
Detaching the rails
Lift up the front of the rail
1.
and unhook it (figure A).
2.
Then pull the whole rail forward
3.
and remove it (Fig. B).
4.
Clean the rails with cleaning agent and a sponge. For stubborn
deposits of dirt, use a brush.
Refitting the rails
First insert the rail into the rear socket, press it to the back
1.
slightly (figure A),
and then hook it into the front socket (figure B).
2.
The rails fit both the left and right sides. Ensure that, as shown
in figure B, levels 1 and 2 are below and levels 3, 4 and 5 are
above.

Detaching and attaching the oven door

For cleaning purposes and to remove the door panels, you can
detach the oven door.
The oven door hinges each have a locking lever. When the
locking levers are closed (figure A), the oven door is secured in
place. It cannot be detached. When the locking levers are open
in order to detach the oven door (Fig. B), the hinges are locked.
They cannot snap shut.
:
Risk of injury!
Whenever the hinges are not locked, they snap shut with great
force. Ensure that the locking levers are always fully closed or,
when detaching the oven door, fully open.
Detaching the door
Open the oven door fully.
1.
Fold up the two locking levers on the left and right (figure A).
2.
Close the oven door as far as the limit stop. With both hands,
3.
grip the door on the left and right-hand sides. Close the door
a little further and pull it out (figure B).
17