C) Safety Rules; D) Authorised Operators - Sav 243.40 Operating Instructions Manual

WORKHOLDING AND AUTOMATION
Continued b) Specifications of Correct Use:
magnetic
chuck
use
positioning
of workpiece
pole pitch P
min. thickness
of workpiece
min.
dimensions
of workpiece

c) Safety Rules:

- Labels for warning and instruction are not to be removed from the magnetic chuck!
- Never use a magnetic chuck that is damaged!
- The pole plate must be clean and ground flat!
- For heavy machining use a positive stop to take up the shear forces!
- Do not machine under reduced holding force without contacting manufacturer!
- The maximum temperature of work piece should not exceed 80 °C / 176°F
- Use a shield for machining to protect you from work pieces or chips & swarth!
- Do not machine a work piece with great height in comparison to width!
- Do not load any work piece with an irregular surface without contacting manufacturer!
Persons with cardiac pacemakers or active implants are not allowed to work within
magnetic fields without consulting a physician!
d) Authorized Operators:
To eliminate failures and hazards, it is important for the operator to be
trained. The operator is responsible for other people within the working
area. The operating manual and instruction must be accessible for the operator.
The instructions must be read and understood by the operator. This also applies to the
operating instructions for the electronic control unit.
BAL 243.40 / .41 / .42 / .99
OPERATING INSTRUCTIONS
For Electro Magnetic Chucks Rectangular
SAV 243.40
grinding
longitudinal
transverse pole pitch
4 mm
2 mm
40x40 mm²
Technical Data subject to change without prior notice
SAV 243.41
grinding
transverse
long. pole pitch
4 mm
2 mm
40x40 mm²
EN
SAV 243.42
grinding
longitudinal
transverse pole pitch
13 / 18 / 25 mm
4,5 mm at P=13
6,0 mm at P=18
8,5 mm at P=25
25x25 mm² at P=13
32x32 mm² at P=18
45x45 mm² at P=25
13