Fuel Line Installation - Club Car Onward 2018 Maintenance And Service Manual

21
Fuel Line
1. Pull out locking clip.
2. Push in on release tab.
3. While pushing in on release tab, pull fuel line off nipple.
3050
Figure 21-11 Fuel Line Connector – To Disconnect

FUEL LINE INSTALLATION

1. At fuel tank:
1.1. Clean the nipple on top of fuel pump module.
1.2. Push fuel line fully onto nipple until it locks in place (Figure 21-12, Page 21-16).
1.3. Engage locking clip by pushing in until fully seated and completely prevents the line from being pulled
off nipple.
2. At engine:
2.1. Connect fuel line to throttle body and secure with spring clamp. See following DANGER.
DANGER
• Ensure line is connected properly to avoid a leak that can cause a fire.
3. Clean spilled and remove any drained gasoline from the area.
4. Connect battery.
See Connecting the Battery- Gasoline Vehicles on page 1-3.
5. Place the Forward/Reverse handle in the NEUTRAL position, chock the wheels, and the neutral lockout switch in
the MAINTENANCE position (Figure 24-1, Page 24-1).
6. Turn the key switch to the ON position and check for fuel leaks. Repeat as necessary to build fuel pressure.
Any leaks found must be fixed.
DANGER
• Repair all fuel leaks before returning the vehicle to service.
7. If no leaks are found, place the neutral lockout switch in the OPERATE position (Figure 24-1, Page 24-1).
Page 21-16 2018 Onward Maintenance and Service Manual
3
2
1
FUEL SYSTEM – SUBARU EX40
1. Push fuel line onto nipple until it locks into place.
2. Push in locking clip until fully seated.
3051
Figure 21-12 Fuel Line Connector – To Connect
1
2