Mount The Sorter Seat To The Desk; Remove The Front Panel Of The Sorter; Place The Sorter On The Sorter Seat; Remove The Rear Cabinet Panel From The Copier And Cut Out The Notch In The Cabinet Panel - Sharp SF-2025 Service Manual

2. Mount the sorter seat to the desk.

Remove the two cut-outs in the cabinet panel on the left side of the
desk.
Secure the two sorter seat mounting screws A to the desk.
Next, hook the sorter seat onto the two sorter seat mounting screws
A which were secured to the desk, and then use the one sorter seat
mounting screw B to secure the sorter seat mounting fixiture as
shown.
Sorter seat

3. Remove the front panel of the sorter.

Loosen the four mounting screws in the front panel of the sorter and
remove the panel.
Sorter seat mounting
screws A
Cut-out
Cut-out
Desk
Sorter seat mounting
fixture
Sorter seat mounting
screw B
Mounting
screws
Front panel
of sorter
Mounting
screws

4. Place the sorter on the sorter seat.

While holding the handle, place the sorter on the sorter seat's guide
rails and push it gently as far back as it will go.
When doing this, confirm that the rollers at the front of the sorter are
correctly seated on the sorter seat.
Rear
Guide roller
Sorter
Sorter seat
5. Remove the rear cabinet panel from the copier
and cut out the notch in the cabinet panel.
Remove the four screws which secure the rear cabinet panel of the
copier to remove the rear cabinet panel.
Cut out the notch (one location) in the cabinet panel.
Mounting
screws
Rear cabinet
panel
Mounting screws
5 – 28
Guide rail Guide rail
Guide roller
Sorter seat
Handle
Notch
Front
Sorter