Table of Contents
Advertisement
Main code
Sub code
25
02
Automatic developer adjustment
•
This is the test command used to monitor the toner sensor and to automatically set the developer.
•
For automatically setting developer, the developing tank is stirred and the toner sensor output is
monitored. The sensor is monitored 16 times in 3 minutes after the stirring started and the mean
value is stored in the memory as the toner density referance value. (See the area marked with an
asterisk in the figure below.) ( Afterwards, referance changes as copies are made to maintain
density.)
C → =↵ →
26
01
Option unit setup
•
Used to set up option unit.
1 When the test command is executed, the presently stored machine setup code is displayed with the
READY lamp turned on.
2 After the READY lamp has turned on, enter an appropriate setup code on the keypad and press the
PRINT switch. Then, the date is stored in the memory and the READY lamp turns off.
Code
+10
°
No need to set "+2 (ADU)". If the ADU is installed, "2" is automatically added.
°
Used to set the code that corresponds to an option unit.
(EX): To set the RADF and desk together with ADU, enter 1+2+4=7, or 1+4=5.
NOTES:
03
Coin vendor setting
0: Cancel, 1: Setting
05
Counter mode setup
1 When the test command is executed, the code of the presently stored mode is displayed with the
READY lamp turned on.
2 After the READY lamp has turned on, enter an appropriate setup code on the keypad and press the
PRINT switch. Then, the code is stored in the memory and the READY lamp turns off.
06
Destination setup
Used to set the destination setting.
1 When the test command is executed, the presently stored model number and the destination code
are displayed (see table below) and the READY lamp turns on.
2 After the READY lamp has turned on, enter the model number and the destination code on the
keypad and press the PRINT switch to store the setting in the memory. The READY lamp then
turns off.
MM
DVBIAS
THV
DL
100m
sec
→ =↵ →
2 →
0
Option
+1
RADF
+2
ADU
+4
Desk
Sorter
(1) Be sure to enter the code that corresponds to the installed option unit.
(2) If option setup is incorrect, a trouble code is displayed. See the trouble code chart.
Code
Total counter
0
Double count
1
Single count
2
Double count
3
Single count
Code
Destination
0
SEC (ES)
1
SEC
* America
2
SECL
3
Other
4
Japan
5
Other
6
SEEG
7
SUK
8
SCA
9
Other
* Energy star
Description
900msec
3min
→ PSW →
→ PSW
5
2
Maintenance counter
Double count
Double count
Single count
Single count
AB/Inch
America
(Inch)
Canada
(AB Japan)
German
U.K.
(AB Export)
Australia
8 – 11
Ref. Page
Advertisement
Table of Contents
