Set Value Recording Sheet - Sharp SF-2220 Service Manual

4. Set value recording sheet

Memorize set values in the column of "Set value" for efficient servicing when the memory trouble occurs and the EEPROm is replaced.
Make a copy of this sheet and use with the service sheet.
Purpose/kind Section
Paper feed section
Adjustment
Optical unit
Developing unit
Specifications
Setting
Fuser unit
Maintenance counter
Counter Developing unit
Main code Sub code Set value
51 02
50 01
46 01
47
48 01
02
25 02
26 06
26 13
43 01
21 01
22 06
07
10 – 3
MC-Service
Contents
Description
Adjustment value of contact pressure of the paper on the main
body resist roller
Copy paper lead edge void amount adjustment
(Resist adjustment A)
Copy paper lead edge void amount adjustment
(Resist adjustment B)
Copy paper lead edge void amount adjustment
(Lead edge void adjustment )
Copy paper lead edge void amount adjustment
(Rear edge void adjustment)
Adjustment value of copy density (exposure level) in each copy
mode and of copy density gradient (exposure gradient)
Manual copy mode density level 1
Manual copy mode density level 5
Manual copy mode density level 1 (Toner save mode)
Manual copy mode density level 5 (Toner save mode)
Auto copy mode density level 1 (Not toner save mode)
Auto copy mode density level 5 (Not toner save mode)
Auto copy mode density level 1 (Toner save mode)
Auto copy mode density level 5 (Toner save mode)
Photo copy mode density level 1 (Not toner save mode)
Photo copy mode density level 5 (Not toner save mode)
The AE sensor and the optical section characteristics memory
data for the change in the copy lamp application voltage
The vertical copy magnification ratio adjustment value
The horizontal copy magnification ratio adjustment value (when
the document table is used)
Toner density initial set value
Destination specifications
Setting of the main motor operation mode in warming up
The set value of fusing temperature
Setting of the maintenance cycle
The developer count of the installed developer unit can be
checked.
The developer replacement cycle of the installed developer unit
can be checked.