Install The Eiom - Lenovo ThinkAgile HX User Manual

Step 1. Disconnect two cables from the EIOM.
Note: Make sure you push the release latch only when disconnecting the signal cable.
Step 2. Turn the thumbscrews counterclockwise.
Step 3. Grasp and push the EIOM slightly towards the front side of the shuttle.
Step 4. Lift the EIOM up to remove the EIOM from the shuttle.
If you are instructed to return the component or optional device, follow all packaging instructions, and use
any packaging materials for shipping that are supplied to you.

Install the EIOM

Use this information to install the EIOM.
"Read the
installation
Guidelines" on
page 41
Before you install the EIOM, touch the static-protective package that contains the new EIOM to any
unpainted surface on the outside of the server. Then, take the new EIOM out of the package and place it on a
static-protective surface.
Note: The minimum networking speed requirement for the EIOM is 1Gbps.
Complete the following steps to install the EIOM.
Step 1. Grasp the EIOM and align the four EIOM tabs with the slots in the shuttle; then, lower the EIOM into
the slots.
• For 10GbE cage (SFP+) model
Figure 35. EIOM installation
• For 10GBASE-T cage (RJ-45) model
"Power off
the compute
node
for this task"
on page 32
Chapter 8
"ATTENTION:
Static Sensitive Device
Ground package before opening"
on page 43
.
Hardware replacement procedures
61