Lenovo ThinkAgile HX User Manual page 64

Before you remove the EIOM:
1. Place the node in maintenance mode by following the procedure
Replacement Documentation
2. Power off all compute nodes and peripheral devices.
3. Disengage all the compute nodes from the enclosure (see
7X21/remove_a_compute_node_from_the_chassis.html
4. Disconnect the power cords and all external cables from the rear of the enclosure.
5. If the cable management arm is installed, remove it (see http://thinksystem.lenovofiles.com/help/topic/
7X21/remove_the_cable_management_arm.html).
6. Remove the shuttle (see "http://thinksystem.lenovofiles.com/help/topic/7X21/remove_the_shuttle.html"
on page ) and place it on the stable work surface.
To remove the EIOM, complete the following steps:
• For 10GbE cage (SFP+) model
Figure 33. EIOM removal
• For 10GBASE-T cage (RJ-45) model
Figure 34. EIOM removal
60
User Guide for ThinkAgile HX Enclosure Node ThinkAgile HX3721 Node
.
Node Shutdown
http://thinksystem.lenovofiles.com/help/topic/
).
in the Hardware