Nilfisk-Advance Advance SC4000 Instructions For Use Manual page 24

A - ENGLISH
DETERGENT SYSTEM USE (ECOFLEX)
Detergent Use (SCRUB AND SOLUTION SYSTEM MUST BE ON): See Figure 2-10.
No detergent is dispensed until the scrub and detergent systems are enabled and the Drive Pedal (3) pushed forward.
• The Detergent Indicator (C6) will be displayed in scrub mode when the detergent system is installed on the machine.
• The Detergent Percentage Indicator (C7) will display the selected percentage when the detergent system is on.
1A. Plain Water Cleaning Mode - During scrubbing, the detergent system can be turned off at any time by pressing the Detergent Switch
(J) to allow scrubbing with water only. Detergent Percentage Indicator (C7) will be blank and Detergent Indicator Bar Graph (C8) will
2A. Detergent Low Mode – Activated by pressing the Detergent Switch (J) when detergent is off (repeated presses will cycle to High
Mode, off and back to low mode). Detergent Percentage Indicator (C7) will display the current low detergent level and Detergent
Indicator Bar Graph (C8)
Low Level".
3A. Detergent High Mode – Activated by pressing the Detergent Switch (J) when detergent is in low mode (repeated presses will cycle to
off, low mode and back to high mode). Detergent Percentage Indicator (C7) will display the current high detergent level and Detergent
Indicator Bar Graph (C8)
Detergent High Level".
4A. Burst of Power Cleaning Mode – Push the Burst of Power Paddle (N) to increase the detergent ratio/percentage for one minute to the
pre-programmed "high" detergent level (as noted in programming instructions below). Detergent system will be turned ON at "low"
countdown timer. Push Paddle (N)
Power runs is adjustable (see "Information Menu Display" submenu "Options").
To program the Detergent High Level
Press the OneTouch™ Scrub switch (M) to activate the scrub system.
1.
2. Press and release Detergent Switch (J) until you have entered the detergent high mode ((C8)
3. Press and hold the Detergent Switch (J)
4.
Ratio = 300:1, 256:1, 200:1, 150:1, 128:1, 100:1, 64:1, 50:1, 32:1, 26:1
CAUTION!
5. Once the desired level is displayed on the screen, stop and it will save the setting after 3 seconds.
6. Whenever the high detergent setting is set to a lower concentration than the current programmed low setting, the low default setting will be
equal to the high setting until changed by the operator.
To program the Detergent Low Level
1. Press the OneTouch™ Scrub switch (M) to activate the scrub system.
Press and release Detergent Switch (J) until you have entered the detergent low mode ((C8)
2.
3. Press and hold the Detergent Switch (J)
4.
percentages that are a lower concentration or equal to the high detergent setting will be available.
5. Once the desired level is displayed on the screen, stop and it will save the setting after 3 seconds.
A - 24
INSTRUCTIONS FOR USE
(J1) will be off.
(C15) will blink for the duration of the Burst of Power process on the display along with a
Advance SC4000 - 56091272
(J1) will be on. See below the steps "To program the Detergent
(J1) will be on. See below the steps "To program the
(C7)
(C7)
9/2022