JVC GY-HC500E Instructions Manual page 72

Error Message
If the Auto White Balance adjustment is not
correctly completed, one of the following
messages will appear for about 3 seconds.
Message
Auto White * NG: Displayed when there is not
Object enough white color on the
(*A or B) object, or when the color
temperature is not suitable.
Use another white object and
adjust the white balance
again.
Auto White * Error: Displayed when the lighting is
Low Light dark. Increase the lighting
(*A or B) and adjust the white balance
again.
Auto White * Error: Excessive illumination.
Over Light Displayed when the lighting is
(*A or B) too bright. Decrease the
lighting and adjust the white
balance again.
White Paint Adjustment
You can fine-tune the white balance saved in
Memory A or Memory B.
1 Select [Camera Process] B [White
Balance] B [AWB Paint] and press the Set
button (R).
The White Paint Adjustment screen appears.
White Balance
AWB Paint
.
2 Adjust the R and B values.
Use the cross-shaped button (JK) to adjust R
value and (HI) to adjust B value.
.
72
Adjusting the White Balance
3 Press the Set button (R).
Status
.
Memo :
1
R
B
Returns to the [White Balance] screen.
White Balance
AWB Paint
Executing Auto White Balance will usually clear
0
the White Paint Adjustment value. But when
[Camera Process] B [White Balance] B [Clear
Paint After AWB] is set to "Off", values will not
be cleared even when Auto White Balance is
executed.
(A P124 [ Clear Paint After AWB ] )
If [White Balance] is assigned to the user button,
0
pressing the assigned user button will display
the AWB Paint Adjustment screen.
(A P46 [Assignment of Functions to User
Buttons] )
R Value
B Value