Connect The Headphone; Connecting Wired Remote Control - JVC GY-HC500E Instructions Manual

Connect the headphone

Audio output from the [x] terminal can be
0
selected using the [A/V Set] B [Monitor] item or
the [MONITOR] selection switch on the camera
recorder.
(A P136 [ Monitor ] )
The different combinations of settings that are
0
output from the [x] terminal and monitor
speaker are as follows.
[MONITOR]
[Monitor]
Selection
Setting
Switch Setting
[CH1] -
[BOTH] [Mix]
[Stereo]
[CH2] -
* Audio is output from the speaker only in Media
mode. Does not output in the Camera mode.
.
Memo :
If both CH1 and CH2 are set to built-in
0
microphone and the [MONITOR] selection
switch has been set to "BOTH", stereo sound is
output from the [x] terminal regardless of the
[Monitor] setting.
[x]
Terminal
Speaker *
L R
CH1 CH1
CH1+CH2 CH1+CH2
CH1 CH2
CH2 CH2
Connecting Wired Remote
Control
You can operate the functions of this unit with a
wired remote control.
Memo :
When the switches of the camera recorder and
0
remote control unit are operated at the same
time, the switch operation of the remote control
unit takes priority over that of the camera
recorder.
1 Connect a wired remote control to the
camera recorder.
Connect the wired remote control (sold
separately) to the [REMOTE] terminal of this
camera recorder.
Connect the wired
remote control
REMOTE
.
Caution :
Turn off the power of the camera recorder when
0
connecting a wired remote control.
2 Turn on the power of the camera recorder.
Connect the headphone
183