Installation Instructions - Project Source EVERFIELD 21-K822-PS-PSD Manual

INSTALLATION INSTRUCTIONS

1. Shut off the water at the supply valves under the sink or
at the main water supply. Disconnect the supply lines.
Remove the existing faucet from the sink.
Clean and dry surface area where new faucet will be
mounted.
2. Apply a thin bead of silicone sealant to the putty plate
(E) on the underside of the faucet body (A).
Carefully slide the shanks (2.1) on the faucet body (A)
through the sink holes. From underneath the sink, thread
the mounting nuts (AA) onto the shanks (2.1) on the
faucet body (A). Check the position of the faucet and
hand tighten until the faucet body (A) is securely
mounted. NOTE: It is helpful to have a second person
hold the faucet in place while tightening the mounting
nuts (AA).
Hardware Used
Mounting nut
AA
3. Optional side spray installation:
If not installing the side spray, skip to step 5.
Insert the sprayer support (C) through the far right hole
on the sink (3.1). From underneath the sink, thread the
side spray mounting nut (BB) onto the sprayer support
(C) and hand tighten.
Hardware Used
Side spray
BB
mounting nut
x 2
x 1
4
1
2
E
AA
3
3. 1
A
2.1
C
BB