Assembly Or Installation Instructions - Project Source MORLEY Manual

ASSEMBLY INSTRUCTIONS
1. Locate the proper place on the vanity top that the drop-
in basin will be installed. Make sure that there is enough
room under the vanity top for the faucet water supply lines,
drain assembly and bottom of drop-in basin. Spacing
on back of drop-in to backsplash of vanity should have
enough distance to accommodate desired faucet.
2. The outside diameter of the drop-in hole should be cut
to accommodate the drop-in basin, please refer to the
template. Trace the cut-out line from the template onto the
vanity (this will be the cut-out line). Make sure that the
cut-out line is centered on the vanity.
3. Confirm that the mark on the vanity lines up with the
drop-in basin. Then make a clearance hole anywhere near
the cut-out line on the inside and then cut out the portion
within the cut-out line.
1
2
3
5