Care And Cleaning - Project Source EVERFIELD 21-K822-PS-PSD Manual

INSTALLATION INSTRUCTIONS (Continued)
7. Attach each of the remaining ends of the water supply
lines (7.1) to the hot and cold water shut-off valves
(7.2) and tighten with a wrench. Do not overtighten.
8. Once the installation is complete, remove the aerator
(8.1) from the spout (8.2) on the faucet body (A). Do
not lose the gasket (8.3) from inside the aerator.
Turn on the water supply and allow both the hot and
cold water to run for at least one minute to flush away
any debris that could cause damage to internal parts.
While the water is running, check for leaks. If a leak
occurs, gently tighten the nut on the connection that is
leaking.
Turn off the water, reinsert the gasket (8.3), and screw
the aerator (8.1) back onto the spout (8.2) of the faucet
body (A).
OPERATING INSTRUCTIONS
The lever handles control the flow of hot and cold water to the faucet. Moving the handle forward opens
the cartridge and causes water to flow from the spout. Rotate the handle on the right side of the faucet
forward for cold water. Rotate the handle on the left side of the faucet forward for hot water. The degree
of handle opening determines the volume of water flow. Returning the handle to the original position away
from the spout on the faucet body stops the flow of water.

CARE AND CLEANING

Clean periodically with a soft cloth. Avoid abrasive cleaners, steel wool, and harsh chemicals as these
will dull the finish and void your warranty.
7
8
8.3
8. 1
6
7. 1
7.2
8.2
A