Assembly Or Installation Instructions - Project Source FL-3212-4W-PS Manual

ASSEMBLY INSTRUCTIONS
1. Locate proper position for pedestal lavatory. Make sure
door clearance and any other obstructions.
Place pedestal basin on pedestal leg and move into the
desired position against the wall. Make sure that the
pedestal basin is levelled on the pedestal leg. With a
pencil, mark the location of the pedestal basin support
holes on the wall.
On marked location on the wall, drill holes with a ⅝" drill
bit if the pedestal will not be attached onto a stud. If the
pedestal will be mounted onto a stud, then drill holes with
a ⅛" drill bit.
Carefully remove pedestal basin from pedestal leg and
install faucet (not included) and pop-up assembly (not
included) as per the manufacturers installation instructions.
2. If installing directly onto the wall without a stud, use toggle
bolts. Push toggle bolts through the backside of the
pedestal basin. Place rubber washer, steel washer and
hex nut loosely on the end of the bolt, in this direct order.
Then place the pedestal basin on the pedestal leg. Then
place the complete unit into the desired position on the
wall at the same time pushing the toggle bolts through the
pre-drilled holes on the wall.
OR
If instalIing directly onto a stud, use lag screws. Place
the pedestal basin on the pedestal leg. Then place the
complete unit in the desired position on the wall. Place
metal washer and rubber washer onto the lag screw
(in this direct order) and at the same time fastening the
pedestal basin directly onto the stud by screwing the lag
screw into the stud.
Hardware Used
AA Toggle Bolt
EE
CC
Rubber Washers
DD Steel Washers
FF
Stainless Steel Nuts
BB Lag Screws
2A
2B
x 2
x 2
x 2
x 2
x 2
x 2
6
1