Table of Contents
Advertisement
L
The first time the appliance is switched on, Let the fire run on maximum setting for
several hours so that the lacquer coating will have an opportunity to set and
possible vapours released can be safely removed by ventilation. We advise you to
be outside the room as much as possible during this process!
Please, note that:
all transport packaging should be removed.
children and pets should not be present in the room.
3 Installation requirements
3.1
The fire
This appliance must be installed in a chlorine-free environment.
The appliance must be built into an existing or a newly to be constructed false
chimney breast.
3.2
False chimney breast
The false chimney breast must be constructed of a non-combustible material.
Always ventilate the space above the appliance by means of the grills or a
comparable alternative with a minimum air supply of 200 cm².
Keep a free distance of min. 50mm on the back site of the fire (See fig. 1.1)
For the finish, use special stucco (min. 100°C resistant) or glass fibre wallpaper to
prevent discoloration or cracks etc. Recommended drying time: for plaster is a
minimum of 24 hours per mm of coat applied.
The false chimney breast and its construction may not rest on the appliance.
3.3
Requirements flue system and outlets
You should always make use of the materials prescribed by Faber International Ltd.
Only by using these materials can Faber International Ltd. guarantee a proper
functioning.
The outside of the concentric flue material can reach a temperature of
Approx 150°C. Make sure of proper insulation and protection in case of transit
through combustible wall or ceiling constructions. And observe sufficient distance.
Make sure that the concentric flue materials are bracketed every 2m. when they
have an extended length, so that the weight of the flue material is not resting on
the appliance itself.
You may never start with a cut-down concentric pipe directly on to the appliance.
4 <
<
<
<
Advertisement
Table of Contents
