Replacing The Canisters; Changing The Program Assignment - Meiko M-iClean U Installation, Operation And Maintenance Manual

Model M-iClean U

11.6 Replacing the canisters

WARNING – Risk of injury from contact with chemicals
•
Observe the safety data sheets and dosing recommendations of the
chemical manufacturers.
•
Use safety eyeware.
•
Wear protective gloves.
•
Do not mix different chemical products.
When using suction lances with fill level detection, a message appears
on the display that the rinse aid/detergent is empty.
1. Pull the suction lance out of the canister.
2. Remove the empty canister.
3. Place the new canister (still sealed) at the storage location, then remove the
lid.
4. Connect the suction lance to the canister. The suction lance must be vertical
in the canister.
5. If air has been drawn in, vent the lines, see page 50.

11.7 Changing the program assignment

The wash programs can be configured according to the operator's
requirements. Depending on the model, there is a choice of glass, dish,
pot, and utensil wash programs. These differ in runtimes, boiler and
tank temperatures, and the amount of water and chemicals used.
1. Switch to level 1, see page 47.
2. Select the GLOBAL item and confirm by checking the box.
3. Select the GLOBAL parameter item and confirm by checking the box.
4. Select the Wash program position 1 item and confirm by checking the box.
5. Change the value with +/- and confirm by checking the box.
9209401 51 / 64