Table of Contents
Advertisement
Section 3 - Configuration
Choose Layer 2 Tunneling Protocol (L2TP) if your ISP uses a L2TP connection. Your ISP will provide you with a username and
password. Click Save at any time to save the changes you have made on this page.
L2TP Server:
Enter the L2TP server's IP address provided by your ISP.
Username:
Enter the username provided by your ISP.
Password:
Enter the password provided by your ISP.
Reconnect Mode:
Select either Always on, On Demand, or Manual.
Maximum Idle
Configurable when On Demand is selected. Enter a maximum idle
Time:
(in minutes) time for the Internet connection to be maintained during
inactivity. To disable this feature, select Always on or Manual as the
reconnect mode.
Address Mode:
Select Static IP if your ISP assigned you an IP address, subnet mask,
gateway, and DNS server addresses. In most cases, however, select
Dynamic IP.
If you select Dynamic IP as the Address Mode:
Primary DNS
Enter the primary DNS server's IP address assigned by your ISP. This
Server:
address is usually automatically obtained from your ISP.
Secondary DNS
Enter the secondary DNS server's IP address assigned by your ISP. This
Server:
address is usually automatically obtained from your ISP.
MTU:
Maximum Transmission Unit (1280~1460) - you may need to
change the MTU for optimal performance with your ISP. The
default is 1400
D-Link M30 AX3000 Dual-Band Wi-Fi 6 Router User Manual
Advanced Settings...
IPv4 - L2TP
37
Advertisement
Table of Contents
