Table of Contents
Advertisement
Section 3 - Configuration
Choose Point-to-Point-Tunneling Protocol (PPTP) if your ISP uses a PPTP connection. Your ISP will provide you with a
username and password. Click Save at any time to save the changes you have made on this page.
PPTP Server:
Enter the PPTP server's IP address provided by your ISP.
Username:
Enter the username provided by your ISP.
Password:
Enter the password provided by your ISP.
Reconnect Mode:
Select either Always on, On Demand, or Manual.
Maximum Idle
Configurable when On Demand is selected. Enter a maximum
Time:
idle time for the Internet connection to be maintained
during inactivity. To disable this feature, select Always on or Manual
as the reconnect mode.
Address Mode:
Select Static IP if your ISP assigned you an IP address, subnet mask,
gateway, and DNS server addresses. In most cases, however, select
Dynamic IP.
If you select Dynamic IP as the Address Mode:
Primary DNS
Enter the primary DNS server's IP address assigned by your ISP. This
Server:
address is usually automatically obtained from your ISP.
Secondary DNS
Enter the secondary DNS server's IP address assigned by your ISP. This
Server:
address is usually automatically obtained from your ISP.
MTU:
Maximum Transmission Unit (1280~1460) - The default MTU is 1400.
You may need to change the MTU for optimal performance with your
ISP.
D-Link M30 AX3000 Dual-Band Wi-Fi 6 Router User Manual
Advanced Settings...
IPV4 - PPTP
35
Advertisement
Table of Contents
