Mixing/Kneading; Cleaning; Storage - Silvercrest SHM 300 D2 Operating Instructions Manual

6.4 Mixing/kneading

1. Ensure that the on/off switch 3 is on 0.
2. Connect the mains plug 8 with a wall
socket.
3. Immerse the beaters 10 / dough
hooks 12 into the food.
4. Switch the device on with the on/off
switch 3 on level 1 first and then set de-
sired speed according to the consisten-
cy of the food to be mixed.
5. Figure C: for short beaks, put the hand
mixer 5 switched off on the base
side 9.
6. To switch off the device, turn the on/off
switch 3 to 0.
7. Pull out the mains plug 8.
8. Hold the device over a bowl or a wash-
basin.
9. Press the eject button 4 down fully. The
beaters 10 / dough hooks 12 are
ejected.
10.Clean the device immediately if possi-
ble.

7. Cleaning

Clean the device prior to its first use!
DANGER! Risk of electric
shock!
 The hand mixer 5, the power cable and
the mains plug 8 must not be immersed
in water or any other liquids.
 Disconnect the mains plug 8 from the
wall socket before each cleaning.
WARNING! Risk of material dam-
age!
 Do not use any astringent or abrasive
cleaning agents.
 All parts except for the hand mixer 5
are dishwasher-safe up to 70 °C.
1. Disconnect the mains plug 8 from the
wall socket.
8
GB
2. If necessary, wipe down the hand mix-
er 5 and the power cable 8 with a
damp cloth several times (if necessary,
with a little detergent). Ensure no water
or moisture gets into the device and that
the motor unit is completely dry before
the next use.
3. The beaters 10 and the dough
hooks 12 can be washed by hand or in
the dishwasher.
4. Let all parts dry completely before you
put them away or use the device again.
Cleaning advice
• Clean the device and all parts as soon
as possible after use in order to prevent
food remnants from drying on.

8. Storage

DANGER for children!
 Keep the device out of the reach of chil-
dren.
DANGER!
 In order to avoid accidents, the mains
plug 8 must never be connected to a
wall socket while in storage.
• Remove the beaters 10 or dough
hooks 12 from the hand mixer 5 for
storage.
• Wind the power cable 8 loosely
around the hand mixer 5.
• Select a location where neither high
temperatures nor moisture can affect the
device.