Override Mode - Projecta IS2000 Instruction Manual

OVERRIDE MODE

Under normal conditions, the IS2000 automatically selects the jump start voltage.
However, the user is required to manually select output voltage if the vehicle battery
voltage is between 0 to 1V DC.
Vehicle Battery Voltage between 0 to 1V DC
Step Detail
1
Press and hold the
2
Press and hold the
WARNING
• Do not allow positive (+)/red and negative (-)/black clamps to touch each other whilst
jump starter is in override mode.
• Pay careful attention when enabling manual override; reverse-connection and short-
circuit protections are disabled.
FLOOD LIGHT
IS2000 provides the user with ample light when checking the vehicle's various
compartments in low light conditions.
Step Detail
1
Press button
Note:
• If the IS2000 flood light is in operation, the "LIGHT ON" icon will appear on the
display or the lamp icon in the upper left corner will light up.
• Flood light will turn off if the internal battery has low charge or after 4 hours if
user does not operate the unit.
8
button for a 12V DC vehicle system
button for a 24V DC vehicle system
Display
24V OVERRIDE MODE
CHECK CLAMP POLARITY/VOLTAGE
Press JUMP START
Display